midicontroller sonderanfertigung ? Einstellungen

[TEKKNIK]

hi leute

weiss jemand wo man sich einen midicontroller bauen lassen kann ,
und wieviel das ungefähr kostet?

Angehängte Datei(en)

 midicontroler.jpg ( 92.78KB ) Anzahl der Downloads: 89

 

[dj AcidGreen/Aci...]

das is wieder mal so eine mini kistn ..

"The Killamix™ DJ, as its name suggests, is aimed at the DJ market. Again this controller is mainly aimed at Ableton Live and Tractor users.

The unit has three channel strips and a master section.

Each channel strip has a Master Volume with six rotary knobs below that. Beneath that again are 6 buttons which illuminate when active, intended for mutes, AB selection and headphone monitor. Beneath that are two pads which can be used for firing off samples. It is intended that on production versions, these pads would be velocity sensitive, allowing them to be used as drum pads.

The master section is similar but beneath the master volume has four rotary knobs and a joystick. Again it has the six buttons, and below that a cross-fader.

The whole unit is finished in brushed aluminium, and has USB and MIDI ports for connection to your computer. Production models would be mains powered, although the prototype shown uses a power adaptor. Production models will have aluminium knobs too, rather than the Moog type knobs on this prototype."


reine kindergarten gschichte für sicher nicht wenig geld ......... (was die da als neu und toll anpreisen is das was eh scho seit jahren gibt .... nur das halt jetzt kenton auch so eine kraxn baut ...)

wie gesagt > ein coder muss her für die bitstream geschichte .. da kannst dann soviel dranhängen dast nedmal mehr weisst wost zerst drehen/drücken ect. sollst ...